Bartscher 110 Serie Instalación Uso Y Mantenimiento página 42

Elements (figg.8, 13 – pagg.4,5)
To substitute the elements, firstly it is necessary to remove the knobs, the drip pan and the control
panel, as shown in figure 8 (pag.4); then remove the hotplate fixing plates and the bulb fixing plates
situated below the hotplate; after that, lift up the front part of the hotplate (fig. 13) by about 5 cm,
move it slightly forward so that the lever which blocks the hotplate at the back, comes out; then turn
it over towards the right. Next, unscrew the fixing screws of the covering (2), remove the covering
(3) and disconnect the element (4) to be substituted, then remove it.
Electric components of the electric fry-top
For the replacement of the selector (4), of the thermostat (5) of the safety thermostat (6), of the
lamps (1), and of the main terminal board (5) of the electric fry-top, it is necessary to unscrew the
fixing screws of the control board (as shown at fig.8 on pag.4), remove it, then disconnect the
electric cables of the component and replace it. After the replacement, connect the electric cables
following the instructions of the wiring diagram.
WHEN SUBSTITUTING, ONLY ORIGINAL SPARE PARTS SUPPLIED BY THE
MANUFACTURER MUST BE USED. THE OPERATION MUST BE CARRIED OUT BY
AUTHORIZED PERSONNEL.
ATTENTION! In the event that components of the gas installation are substituted, it is
necessary to check for tightness and the correct functioning of the various parts.
THE MANUFACTURER RESERVES THE RIGHT TO WITHOUT NOTICE MODIFY
THE FEATURES OF THE APPLIANCES DESCRIBED IN THIS MANUAL.
Pag. 41/66