Newtec NT07 Guia De Inicio Rapido página 4

GB - INFORMATIVE NOTE
Please read this informative note through carefully prior to use and prior to any maintenance work. The purpose
p
of this information contained herein is to assist and direct the user in choosing and using the PPE. Neither the
manufacturer nor the distributor can be held liable for an incorrect use of the PPE. This informative note must be
kept for the duration of the PPE.
PPE Model: cod. 121036 - mod. NT07
PPE FEATURES
Full body harness is a PPE against falls and it complies with EN 361 standard. The harness is equipped additionally with
positioning belt which complies with EN 358 standard.
PPE DESCRIPTION
Full body harness is made of polyamide webbings, which are sewn and connected by metal buckles.
This configuration guarantees full safety and comfort work.
BASIC EQUIPMENT
- Dorsal attaching ring: for connecting a fall arrest device (ex: lanyards, energy absorbers, ...);
- Sternal attaching loops: for connecting a fall arrest device;
- Side attaching rings of the positioning belt: can be utilized only to attach a positioning lanyard, according to EN 358;
- Connecting and adjusting buckles: for comfort wearing and using of the harness.
CAPTION
1- Elastic brace
2 - Chest strap
3 - Tool holders
4 - Adjusting buckle of the shoulder strap
5 - Connecting buckle of the chest strap
6 - Sternal attaching loops
7 - Side attaching rings of the positioning belt
8 - Positioning belt
9 - Adjusting buckle of the positioning belt
10 - Thigh strap
11 - Connecting buckle of the thigh straps
12 - Dorsal attaching ring
13 - Identity label
CE MARK
The CE mark means that this article is a Personal Protective Equipment conforming to the essential health and
safety requirements set forth in the Directive 89/686/EEC and has been certified by the Notified Body CETE
A
APAVE SUDEUROPE, BP193, 13322 MARSEILLE, FRANCE, n°0082. In addition, the manufacturer is subjected
to the control of finished product CE quality guarantee by the Notified Body CETE APAVE SUDEUROPE, BP193,
13322 MARSEILLE, FRANCE, n°0082.
MARKING IDENTIFICATION
1 - Model
2 - Article code
3 - European standards
4 - CE Mark
5 - N° of the inspecting Notified Body
6 - Read the informative note
7 - Month and year of manufacture
8 - Serial number
9 - Factory identification
10 - Distributor's Mark
PRE-USE INSPECTION
Before each use, a person who is going to use the PPE, has to execute a close visual examination of all components, in order
to check if some mechanical, chemical or thermal defects are present. If some doubt arises about the good condition and the
right functioning of the PPE, it has to be withdrawn from use. Then the PPE must be sent to the device manufacturer or to his
certified representative to carry out a detailed inspection and the eventual repair.
HOW TO PUT ON THE HARNESS
1 - Take the harness by the dorsal at-
taching ring;
2 - Put on the shoulder straps one after
one, take care do not twist them;
3 - Connect front plastic clip and adjust
the length of the chest strap;
4 - Pull one and then other thigh straps
through crotch, take care do not twist
them;
5 - Connect the buckle and adjust
thelength of the positioning belt.
a
b
d
c
g
h
k
a
b
d
c
a b
Sollevare l'imbracatura dalla bbia di
cod.121036 - mod. NT07
FRONT VIEW
e
m
f
i
c
g
j
e f
c d
BACK VIEW
l
f
i
g i
h j
e