Making Soymilk, Nut Milks, Or Rice Milk - Tribest Soyabella SB-130 Manual De Instrucciones

B. MaKIng sOYMILK
Follow these instructions to make fresh soy milk, nut milk, or rice milk.
1. Soak soybeans: Use the measuring cup and take a full cup of dry soybeans (2.5oz –
3.5oz., 70g – 95g). Rinse soybeans thoroughly and leave to soak for 4-6 hours or overnight.
• TIP: When soaking the beans, put beans directly into the milk screen and place the
screen into the utility cup. Pour water into the utility cup to soak the beans and let it sit.
2. Add water to stainless steel chamber: Fill the stainless-steel chamber with water so
that water level is between the upper and lower water-level lines. You can control the
consistency of the soybean milk by adding more or less water. You may add warm water to
shorten the processing time. Do NOT add water over 104ºF (40ºC).
3. Load soybeans and attach the milk screen to the head unit: Drain the soybeans and
load them into the milk screen. Attach the milk screen to the head unit by moving the blade in
a side-to-side motion to allow the screen to slide properly into place. Lock the milk screen by
turning it counter-clockwise (markings on the milk screen indicate the proper lock and unlock
directions).
• CAUTION: BE SURE THE SCREEN IS PROPERLY LOCKED IN PLACE! If the screen
becomes loose during operation, the spinning blade could damage the screen.
4. Assemble machine and run MILK function: Connect the head unit to the stainless steel
chamber. Make sure the upper plug slides into the upper plug receptacle on top of the handle.
Plug the power cord into the power cord receptacle, and connect the other end to a wall
socket. Soyabella will beep and a red light will flash. Press the "MILK" button on the head
unit, and the red light will turn solid. The cycle will take approximately 15 minutes. When
finished, the indicator light will blink green, and the machine will beep.
5. Pour milk and enjoy: Unplug the base unit. Lift the head unit from the stainless steel
chamber. When removing the head unit, do not touch the screen, as it will be hot. Make sure
that all milk drains from the screen before moving the head unit away from the stainless steel
chamber. Place the head unit with the screen still attached into the utility cup to cool, making
sure that the handle under the steel screen fits within the corresponding groove in the plastic
utility cup. Carefully pour milk from the stainless steel chamber.
• CAUTION: Soymilk will be hot. Allow milk to cool before serving.
• TIP: Add your favorite ingredients to flavor your soymilk. Add a pinch of sea salt, brown
sugar, vanilla, or any other flavors you like.
• Note: To avoid any build-up that may block the holes of the milk screen, clean the milk
screen as soon as possible. See page 12 for cleaning instructions.
OPeRaTIng InsTRuCTIOns
EN
9