Overheating Protection; P Rogramming The Speed Controller - df models KL-35 Manual De Instrucciones

Overheating protection

If the temperature of the speed controller exceeds the factory-programmed value (95°C) for
more than 5 seconds, the speed controller will turn off the power supply to the motor.
The overheating protection can be switched off for racing operation!
Signal loss
If there is not control signal for 0.2 seconds, the speed controller will turn off the power supply
to the motor.
Blocking protection
If foreign matter blocks the drive train or the motor itself, the speed controller will turn off the
power supply to the motor.
8. p
rogramming thE spEEd controllEr
The speed controller has more adjustments for advanced drivers:
1� 2 operating modes "Forward with Brake" and "Forward/Reverse with Brake"
2� 8-stage "drag brake" setting
3� 6-stage selection of the interrupting voltage
4� 4-stage adjustment of the start-up behaviour ("punch") from "soft" to "very aggressive"
5� 4-stage setting of the maximum braking strength
6� 4 reverse speeds
7� 4-stage setting of the braking strength when the braking takes affect
8� 3-stage neutral operation
9� 8-stage motor timing (only with sensorless motors)
10� Motor type (no selection possible)
11� Overheating protection (95°C) on/off
The programming of the speed controller is done via the set button and the display of the red
and green LEDs.
-  -