df models KL-35 Manual De Instrucciones página 26

Start of the programming mode:
> Switch the speed controller off.
> Switch on the transmitter.
> Press and hold down the set button while you switch on the speed controller.
> The red LED blinks.
Programming:
If you press and hold the set button after starting the programming mode, the green LED will
start to blink once and you are in the first programing step.
If you continue to press the set button, the green LED will blink twice after 3 seconds, the num-
ber of blinking signals will increase by 1 for each additional 3 seconds.
> Hold the set button until you have reached the desired programming step (number of pro-
gramming steps = number of blinking signals of the green LED).
> Release the set button to confirm the desired programming step.
> Press the set button once again.
The red LED will blink once for the first selection option.
> Press the set button again, the red LED will blink twice for the second selection option.
> Press the set button until the number of blinking signal matches the number of the respective
selection option of the according programming step.
Example
1. Programming step
> The green LED blinks once.
You are in the first programming step "operating modes".
> Release the set button to set the first programming step "operating mode".
> The red LED blinks once for the first selection option: operating mode "forward with brake"
> If you want to quit programming here, switch off the speed controller and and restart it
subsequently.
> Or: press the set button again until the desired value has been reached.
Press the set button twice, the LED button will blink twice:
Operating mode "forward/reserve with brake"
-  -
1100_1101/V1/0110