- Only use recommended or equivalent lubricants, oils or greases.
- Avoid mechanical shocks as they may cause failures or malfunction.
- Avoid penetration of water, dirt or dust into mechanical or electrical components of the
machine.
-Do not modify original characteristics of the machine.
-Do not remove, tear off or maculate any labels attached to the machine. If any labels
have been removed or are no longer legible contact your nearest Authorized Technical
Assistance for replacement
4.2 Caution and Observations before Turning on the Appliance
IMPORTANT
Carefully read ALL INSTRUCTIONS of this manual before turning the machine
ON. Check that you have completely understood all information. If you have any
question contact Skymsen or the closest Authorized Technical Assistance.
4.2.1 Danger
An electric cable or electric wire with damaged jacket or bad insulation could cause
electrical chocks as well as electrical leak. Before use check conditions of all wires and
cables.
4.2.2 Advices
Be sure ALL INSTRUCTIONS in this manual have been thoroughly understood. Every
function and operational procedure have to be very clear to the operator. Contact your
nearest Dealer for further questions. Any manual command (switch, button or lever) shall
be given only after being sure it is the correct one.
4.2.3 Precautions
The electric cable has to be compatible with the power required by the machine. Cables
that touch the floor or are close to the machine need to be protected against short circuits
Oil reservoir has to be full up to the required level as indicated. Check the level and add oil
when necessary.
14