ECOVACS DEEBOT N8+ Manual De Instrucciones página 23

No. Malfunction
DEEBOT fails to auto-empty
14
the Dust Bin.
There is debris in the Dust
15
Container.
DEEBOT leaks dust or debris
16
while cleaning.
17 The Base is dirty.
Wi-Fi Connection
Before Wi-Fi setup, make sure DEEBOT, mobile phone, and Wi-Fi network meet the following requirements.
DEEBOT and Mobile Phone Requirements
• DEEBOT is fully charged and the power switch of DEEBOT is turned on.
• Wi-Fi status light slowly flashes.
• Turn off mobile phone's cellular data (you can turn it back on after setup).
Wi-Fi Network Requirements
• You are using a 2.4GHz or 2.4/5 GHz mixed network.
• Your router supports 802.11b/g/n and IPv4 protocol.
• Do not use a VPN (Virtual Private Network) or Proxy Server.
• Do not use a hidden network.
• WPA and WPA2 using TKIP, PSK, AES/CCMP encryption.
• WEP EAP (Enterprise Authentication Protocol) is not supported.
• Use Wi-Fi channels 1-11 in North America and channels 1-13 outside North America (refer to local regulatory agency).
• If you are using a network extender/repeater, the network name (SSID) and password are the same as your primary network.
Possible Causes
The Auto-Empty Dust Bin is not installed.
The Dust Bag is full.
The Auto-Empty Outlets on the Auto-Empty
Dust Bin is stuck by debris.
Dust Evacuation Tube is blocked.
Fine particles are absorbed inside the Dust
Container through the Dust Bag.
The Dust Bag is damaged.
The Auto-Empty Outlets are stuck by debris.
Main Brush has debris on it and requires cleaning.
Solutions
Please install the Auto-Empty Dust Bin with two Auto-
Empty Outlets on the bottom.
Replace the Dust Bag and close the Dust Container Lid.
Uninstall the Auto-Empty Dust Bin and clean the debris
on the Auto-Empty Outlets.
Clean the Dust Evacuation Tube.
Clean the Dust Container Lid and inner wall.
Check the Dust Bag and replace it.
Uninstall the Auto-Empty Dust Bin and clear the debris.
Clean the Main Brush.
23 EN