Greasing The Gas Tap; Replacing Parts; Instructions And Warnings For The Replacement Of Parts; Replacement Of The Burner Nozzle - Angelo Po 0N0GRG Manual De Uso

To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Pull off the knob (A).
2)
Take out the screws (B) and take down the
3)
dashboard (C).
Take out the screws (D) and extract the cap(E).
4)
Pull off the cone (F).
5)
Clean the cone (F) and its seat.
6)
Coat the cone with grease (F), fi t it in its seat
7)
and turn it a few times.
Pull off the cone (F) to remove the excess
8)
grease.
Replace the cone (F), the cap (E), the control
9)
panel (C) and the knobs (A).

INSTRUCTIONS AND WARNINGS FOR THE REPLACEMENT OF PARTS

Important
Before carrying out any replacement procedure,
activate all the safety devices provided and deci-
de whether staff at work and those in the vicini-
ty should be informed.
In particular, turn off the gas supply tap and
prevent access to all devices which might cause
unexpected health and safety hazards if turned
on.
To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Pull off the knob (A).
2)
Take out the screws (B) and take down the
3)
dashboard (C).
Unscrew the nozzle (D) and replace it with
4)
the one suitable for the type of gas in use (see
table at back of manual).
Replace the control panel (C) and the knobs
5)
(A) on completion of the operation.
3320070_inst_GB_rev.1

GREASING THE GAS TAP

REPLACING PARTS

REPLACEMENT OF THE BURNER NOZZLE

- 13 -
A
C
B
If work parts have to be replaced, use original
spare parts only.
The manufacturer declines all responsibly for
injury or damage to components due to the use
of non original parts, or extraordinary work on
the appliance which may modify the safety re-
quirements without the manufacturer's autho-
risation.
When ordering components, follow the instruc-
tions provided in the parts catalogue.
A
C
B
E F
C
D
C
D
GB
ENGLISH