Covering Installation - EdilKamin LOGO Instrucciones De Uso

fi g. 1
fi g. 3
B
K
fi g. 5
N X
K
B
S
N1
N2
fi g. 7
fi g. 9
N-X
V
B

COVERING INSTALLATION

fi g. 2
A
fi g. 4
X
N
fi g. 6
X
N
P
N1
fi g. 8
fi g. 10
T
Hardware included:
no. 2 upper brackets for ceramic fi xing (K - fi g. 3-4)
no. 2 upper brackets for ceramic fi xing (N1 - fi g. 7)
no. 4 Flat ceramic adjustment bracket (X - fi g. 4)
no. 4 Angle ceramic adjustment bracket (N - fi g. 4)
no. 4 Self-tapping screws 4,2 x 9,5
no. 12 Knurled pins
no. 4 Screws M5 x 8
nr. 4 Rubber spacers (N2 - fi g. 7)
Fig. 1
This fi gure represents the stove after it has been unpacked.
Fig. 2
The stove is delivered with the metal part of the lower side
coverings (A) already assembled.
ASSEMBLY OF CERAMIC SIDE COMPONENTS
Fig. 3
- Apply the upper ceramic fi xing brackets (K) on the top rear
part of the ceramic panels, with the engraved arrow facing the
front of the stove, securing them in the dedicated holes using
the pins supplied.
Note.: the side ceramic components must be mounted with the
lower groove facing the front of the stove (S - fi g. 7).
In addition, inside the LT or RT version is indicated.
Fig. 4
- Fix the fl at ceramic adjustment bracket (X) to the angle ce-
ramic adjustment bracket (N) using the 4.2 x 9.5 self-tapping
screws supplied.
Fig. 5 - 6
- Apply the previously assembled brackets (N -X) on the upper
ceramic fi xing bracket (K), securing them in the dedicated
holes using the pins supplied.
Fig. 7
- Apply the lower ceramic fi xing brackets (N1) on the bottom
rear part of the ceramic panels, with the engraved arrow facing
the front of the stove, securing them in the dedicated holes
using the pins supplied.
Fig. 8 - 9
- Flank the lower part of the ceramic side, fi tting the lower ce-
ramic fi xing bracket (N1) on the pins (P) present on the frame
of the stove.
- Complete the operation by joining the upper part of the cera-
mic side and screwing the brackets (X-N) into the holes on the
top (use the M5x8 screws supplied -V).
ATTENTION: DURING OPENING MAKE SURE THE
DOOR DOES NOT COME INTO CONTACT WITH THE
SIDE CERAMIC ELEMENTS.
VERIFY THE CORRECT COUPLING OF THE SIDE
CERAMIC COMPONENTS WITH THE CAST IRON
SIDES, MAKING ANY NECESSARY ADJUSTMENTS
USING THE SCREWS (V) AND THE BRACKETS (N-X).
IF NECESSARY USE THE PADS (N2) SUPPLIED.
CERAMIC TOP ASSEMBLY
Fig. 10
Place the ceramic top (T) centring it in the housings on the cast
iron top.
- 25
-