Fox FLOAT iCD Manual Del Usuario página 12

INTERNAL WIRING
Some frames may have internally routed wires. Do not remove the wire holders which are attached to these
built-in type wires, as these prevent the electric wires from rattling inside the frame tubes.
Figure 18: Internally Routed Wires (EW-SD50-I)
20
mtbservice@ridefox.com
EMAIL
CHANGING SWITCH CONFIGURATION
TWO POSITION MODE
There are two identically threaded holes in the switch base, for the switch stop fi xing bolt and the base
fi xing bolt. Interchanging these bolts, moving the switch stop, and inverting the clamp bands allows you to
mechanically change the switch actuation direction. The switch stop occupies the space of a potential third
switch position.
Figure 19: Switch Stop and Threaded Hole
See Figure 20: "Default Confi guration of the Two Position Switch (Right Side)", which shows how the switch
is internally assembled to actuate climb mode when the rotary knob actuator is pressed downwards with a
right-mounted switch, or upwards when the switch is mounted on the left.
21
service.ridefox.com
WEB