Troubleshooting Tips - Fox FLOAT iCD Manual Del Usuario

3. As shown in Figure 13: "Installing the Switch Junction Box", attach the switch junction box to the brake
housing with the supplied cable ties. Be sure to position the junction box so the LED power indicator is
not obscured. Use the brake housing cable clip to fasten the electric cable to the brake housing.
Figure 13: Installing the Switch Junction Box
As shown in Figure 14: "Wire Covers (SMEWC2)", special wire covers are available in 50 mm or 300 mm
lengths, for cleanly mounting the wire harness externally on your bike frame.
Note: See "Internal Wiring" for information about internal wire routing.
Cable ties can also be useful for attaching the wire harness along existing bicycle control cables. Make sure
that normal operation of bicycle controls is not compromised, however.
Figure 14: Wire Covers (SMEWC2)
12
mtbservice@ridefox.com
EMAIL
The strength of the adhesive for fastening the cable wire harness cover to your frame is intentionally weak,
which serves to protect your frame paint from damage if you ever remove it to replace the electric wires.
Note: When removing the electric wire cover, do not remove it too vigorously as this could damage the frame paint.
If the electric wire covering wears out and peels off , replace it.
4. The iCD setup process is now complete. Test your setup by operating the switch and making sure the
system cycles normally between climb and descend modes.

TROUBLESHOOTING TIPS

Note: If the following troubleshooting tips fail to help correct a problem you may be experiencing, contact FOX at
1.800.369.7469 or mtbservice@ridefox.com.
Issue Probable Cause(s)
System does not function normally. Low battery, or bad wire connectivity.
On a full suspension setup, the fork Low battery charge.
operates but the shock does not.
Harness wire disconnects when riding. Not enough slack in frame mounting
of cable harness.
Solution(s)
• Check for battery charge status; see
"LED Power Indicators".
• Check for proper harness wire
connectivity. All connectors should
be clicked into place, with no visible
damage to the wires.
• Disconnect the battery, wait for one
minute, then reconnect the battery to
restart the system.
• Connect the system to the USB PC
interface device. The device can be
purchased separately from your local
authorized FOX dealer, or contact
FOX: 1.800.369.7469, mtbservice@
ridefox.com
This is normal if the battery charge
level is between 0-25% (see "LED
Power Indicators"). Fully recharge the
system battery.
Check wire length and ensure
adequate slack in mounted cable
harness throughout shock and full
handlebar travel.
13
service.ridefox.com
WEB