Fox FLOAT iCD Manual Del Usuario página 3

ICD WIRING AND SUSPENSION CONFIGURATIONS
Note: Frame and shock clearances with the battery mount may determine your wire routing choice.
Refer to the following suspension setup confi gurations to help you decide which setup would be the best
for your needs.
HARDTAIL SETUP
• Two wires are required; one from switch to fork actuator, and a second from fork actuator to battery
mount.
• The battery mount can be mounted on either the downtube or seat tube.
• The wires are interchangeable and therefore can be arbitrarily inserted into the fork actuator.
Figure 1: Suggested Wiring Confi guration: Front Suspension Only (Hardtail)
2
mtbservice@ridefox.com
EMAIL
HORIZONTAL FULL SUSPENSION SETUP
• Three wires are required; one from switch to fork actuator, a second from fork actuator to shock
actuator, and a third from shock actuator to battery mount.
• The wires are interchangeable and therefore can be arbitrarily inserted into the fork and shock
actuators.
• The shock can also be installed opposite of what is shown in Figure 2, which may help improve your
water bottle clearance.
Figure 2: Suggested Wiring Confi guration: Horizontal Full Suspension
3
service.ridefox.com
WEB