Fox FLOAT iCD Manual Del Usuario página 4

VERTICAL FULL SUSPENSION SETUP
• Three wires are required; one from switch to fork actuator, a second from fork actuator to shock
actuator, and a third from shock actuator to battery mount.
• The wires are interchangeable and therefore can be arbitrarily inserted into the fork and shock
actuators.
Figure 3: Suggested Wiring Confi gurations: Vertical Full Suspension
4 mtbservice@ridefox.com
EMAIL
DEFAULT ICD SWITCH CONFIGURATIONS
By default, the switch is a two position confi guration, the same confi guration as the most commonly
used by FOX world class racers. For a full suspension setup, both fork and rear shock are actuated
simultaneously.
The switch can be operated by rotating it with your thumb using the thumb actuation indentation, or
with the index fi nger actuation lever. See "iCD Switch Parts Identifi cation" for the names of all iCD parts
referenced in this owner's guide.
1. Pressing the rotary knob down actuates climb mode for a right-mounted switch; if you have the
switch mounted on the left side, pressing the switch up actuates climb mode.
2. Pressing the rotary knob up actuates descend mode (open); if you have the switch mounted on the left
side, pressing the switch down actuates descend mode.
For advanced information about changing the default switch confi guration setup, see "Changing Switch
Confi guration".
INSTALLING THE SWITCH
1. The switch can be mounted on either the left or right side of the handlebar.
Note: As shown in Figure 4: "Left and Right Switch Mounting Setups", make sure the index fi nger actuation lever on the
rotary knob is positioned immediately next to the hand grip, regardless of which side your switch is installed.
Figure 4: Left and Right Switch Mounting Setups
service.ridefox.com
WEB
5