Final Installation - Harbor Breeze PLM52CB5D Manual De Instrucciones

WIRING
2. Wrap electrical tape around each individual wire
connector (AA) down to the wire as shown in Fig. 2.
WARNING: Make sure no bare wire or wire
strands are visible after making connections. Place
green and white connections on opposite side of box
from the black and blue (if applicable) connections.
Turn spliced/taped wires upward and gently push
wires and wire connectors (AA) into outlet box.
Hardware Used
E3 Wire Connector
AA
IMPORTANT: Using a full range dimmer switch to
3.
control fan speed will cause a loud humming noise
from fan. To reduce the risk of fire or electrical
shock, do NOT use a full range dimmer switch to
control fan speed. (Fig. 3)

FINAL INSTALLATION

1. Locate two canopy mounting screws (L) on
underside of mounting bracket (C) and remove
canopy mounting screw (L) closest to the open end
of the mounting bracket (C). Partially loosen the
other canopy mounting screw (L). Lift canopy (B) to
mounting bracket (C). Place rounded part of slotted
hole in canopy (B) over loosened canopy mounting
screw (L) in mounting bracket (C) and push up.
Twist canopy (B) to lock. Re-insert canopy
mounting screw (L) that was removed, and then
tighten both canopy mounting screws (L). Slide
canopy cover (I) up to canopy (B). Press up gently
but firmly on canopy cover (I) until you hear it snap
onto the bottom of the canopy (B). (Fig. 1)
2
AA
x4
3
For illustrative purposes only--not
intended to cover all types of controls
1
10
AA
AA
3
2
1
Dimmer
Speed
Switch
Switch
L
A
B
I