Connecting The Water Inlet Hose - Listo LF512-L2b Instrucciones De Uso

C
ONNeCTINg The wATeR INLeT hOSe
1. Depending on its technical characteristics, your machine can be fitted with
either a single water inlet hose connection (cold water) or a double connection
(hot and cold water). The hose with the white cap must be connected to the cold
water inlet and the one with the red cap to the hot water inlet (if applicable).
To prevent leaks at the joints, 1 or 2 nuts (depending on the technical characteristics
•
of your machine) are provided in the hose packaging. Fit these nuts on the end of
the water inlet hose(s) to be connected to the water supply.
2. Connect the new water inlet hoses to a 3/4" threaded tap.
Connect the white end of the water inlet hose to the white water inlet valve located
•
at the rear of the machine and the red end of the hose to the red water inlet valve
(if available).
Tighten the fittings by hand. (II If in doubt, consult a qualified plumber.
•
For optimal operating efficiency, a water pressure between 0.1 and 1 MPa is
•
required (a pressure of 0.1 MPa corresponds to more than 8 litres of water flowing
per minute with a fully open tap).
V.1.0 40