Mopar 4280360 Manual Del Usario página 15

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

28. Remove and disconnect the trunk release switch (1).
29. Remove the two fasteners (2) below the vent and trunk
release switch.
30. Grasp the LH top pad up near the defroster duct and
pull up and rearward to disengage the retaining clips.
CAUTION: The Instrument Panel Top pad may be hard
to unsnap from the instrument panel. Be sure not to
mar, scuff, or damage the instrument panel pad.
31. Remove the LH top pad and insulator from the vehicle.
32. Remove the fastener (1) securing the ignition anti­theft
bracket (2) and remove the bracket.
33. Remove the fasteners securing the ignition switch (4).
34. Accessing through the radio cavity, remove the fas­
tener securing the wireless control module (3).
35. Remove the WCM (3) through the radio cavity, discon­
nect and discard.
36. Locate the remote start antenna mounting loca­
tion/cavity located on top of the I/P, forward of the
intstrument cluster. If the fastener inserts are not
present, install the kit supplied inserts.
37. Mount the remote start antenna (1) to the I/P using
the locating tabs and the kit supplied fasteners (3).
Tighten the fasteners securely.
38. Using a fish tape or equivalent, route the antenna
harness (2) through the opening between the antenna
and cluster to the center stack area.
damage to the harness, make sure the harness
is routed behind the structure and away from any
radio/trim panel mounting locations in the center
stack area.
Jan 19, 2011
To avoid
4280360
15
K6861246

Publicidad

Tabla de contenido
loading

Tabla de contenido