Mopar 4280360 Manual Del Usario página 23

23
RESTORE VEHICLE CONFIGURATION
NOTE: The technician should have cut the KEY FOBIK Blanks using the original vehicle's Key FOBIK as a tem­
plate. Please make sure the KEY FOBIK Blanks have been cut prior to programming. If this step has not been
performed, please perform at this time.
CAUTION: Read all notes and cautions for programming procedures.
NOTE: Prior to programming, have the vehicle PIN readily available before running the routine. If necessary,
obtain the four digit PIN from the dealership's parts department.
CAUTION: If the PCM and WCM are replaced at the same time, the PCM MUST be programmed before the WCM.
1. When prompted, enter the four digit pin number obtained from the dealership parts department.
2. Connect a battery charger to the vehicle.
3. With the wiTECH diagnostic application, perform the following steps form the Initial Start Up Screen:
• Select the "DIAGNOSTIC PROCEDURES" tab
• Highlight "RESTORE VEHICLE CONFIGURATION"
• Select the "Run Diagnostic" button
• Select "CONTINUE"
• Verify that the vehicle VIN number is correct
• Once verified, select the "Correct VIN" button
• Note On­Screen instructions and select the "Close" button
PROGRAMMING THE WCM
CAUTION: Read all notes and cautions for programming procedures.
NOTE: Have the vehicle PIN readily available to enter whenever prompted before running the routine.
CAUTION: If the PCM and WCM are replaced at the same time, the PCM MUST be programmed before the WCM.
1. Connect a battery charger to the vehicle.
2. With the wiTECH diagnostic application, perform the following steps:
• Select "WIRELESS CONTROL MODULE (WCM)"
• Select the "MISCELLANEOUS FUNCTIONS" tab
• Highlight "WCM REPLACED"
• Select the "Start Misc Function" button
• Select "NEXT"
• Enter the PIN when prompted.
• Select "NEXT"
• Verify that the PIN number is correct
• Once verified select "NEXT"
• Select "NEXT"
• Note On­Screen instructions and select the "FINISH" button
• Cycle ignition key twice after the successful routine completion.
PROGRAMMING IGNITION KEYS TO THE WCM
CAUTION: Read all notes and cautions for programming procedures.
NOTE: Have the vehicle PIN readily available before running the routine
1. Connect a battery charger to the vehicle.
2. With the wiTECH diagnostic application, perform the following steps:
• Select "WIRELESS CONTROL MODULE (WCM)"
• Select the "MISCELLANEOUS FUNCTIONS" tab
• Highlight "PROGRAMMING IGNITION KEYS OR KEY FOBS"
• Select "NEXT"
• Enter the PIN when prompted.
• Select "NEXT"
4280360
Jan 19, 2011 K6861246