Underload Sensitivity - Franklin Electric SubDrive Connect Instrucciones De Configuración

SubDrive Connect Surface Pump
Minimum Frequency
Minimum frequency selection is only used in surface pump applications. Setting DIP SW3
Position 6 in the "OFF" (down) position will set the minimum output frequency to 30Hz (default).
Setting DIP SW3 Position 6 in "ON" (up) position will set the minimum output frequency to 15Hz.

Underload Sensitivity

See owner's manual for setup.
Pressure Setpoint
See owner's manual for setup.
Advanced Setup (Wi-Fi / FE Connect Mobile App)
Some advanced features can be modified when connected to the SubDrive Connect unit
using the FE Connect mobile app. See owner's manual for instructions on how to connect
to the drive using Wi-Fi and the FE Connect mobile app.
Setup
The Setup screen allows for selection between submersible or surface pump applications. For
submersible pump applications, see owner's manual for setup instructions. For surface pump
applications, the Setup screen allows for the setup of additional features of the drive including:
Pump/Motor Settings
• Drive Application*
• Motor Type (only 3-phase)*
• Motor Frequency*
• Motor Poles
• Motor Overload Current*
• Minimum Output Frequency*
• Maximum Output Frequency*
Pressure Control
• Sensor Type*
• Pressure Transducer Range*
• Primary Setpoint*
• Drawdown
• System Response (Select Slow, Med, Fast, or Custom values for P, I, and R)*
Underload
• Underload Sensitivity*
• Underload Off Time
• Prime Delay
Duplex Alternator
•Configuration
4