Installing Refl Ectors & Supports - L.B.White Sentry ST60 Manual Del Propietário

14
Sentry Tube Heaters
Installing Reflectors & Supports
Refer to Fig. 8 for the following instructions:
1. Slide the refl ector through the hangers until it is
about 1 or 2 inches away from the burner box.
2. Attach end cap to end of this refl ector.
Use 4 U-clips. Push this refl ector up to burner box.
3. Connect the refl ectors using the dimpled connec-
tor strips. See below.
FIG. 8
OVERHEAD
REFLECTOR USING CONNECTION STRIPS:
• Insert a connection strip halfway into the folded channel
at both sides of a refl ector, at the end without fl anges.
• Slide this end of the refl ector through the hanger and
push it fi rmly into the folded channels of the refl ector at
the burner box.
• The unfl anged end of the refl ector will overlap the
fl anged end of the adjacent refl ector.
Owner's Manual • Sentry
4. Repeat Steps 3 and 4 for remaining refl ectors.
5. Attach remaining end cap to last refl ector with
CONNECTOR STRIP
(DIMPLES UP)
DOTTED LINES:
INDICATE CONNECTOR
WITHIN CHANNEL
U-clips.
OVERHEAD 45° ANGLE