Care And Maintenance; Troubleshooting Guide - Beurer BM 28 Manual De Instrucciones

Press the Memory Button M and select a user memory (1-4)
by pressing the M Button again.
Average Values:
• Press the + Button; " " flashes on the display.
The average of all saved measurements in the
selected user memory is displayed.
• Press the + Button again. " " flashes on the
display. The average value of the morning
measurements for the last seven days is
displayed (morning: 5:00 AM – 9:00 AM).
• Press the + Button a third time. " " flashes
on the display. The average value of the
evening measurements for the last seven
days is displayed (evening: 6:00 PM – 10:00
PM).
Individual Measured Values:
• Press the Memory Button again and the last
individual measurement is displayed.
• To shut the device off, press the START/
STOP Button .
You can exit the menu at any time by pressing the START/
STOP Button
Clearing Memory:
• To clear one of the user memories, you must
first select it.
• Start individual measurement access as
described above and select a user memory.
• Press and hold both the Memory and SET
Buttons for five seconds. All values in the
selected user memory will be deleted.

10. Care and Maintenance

• Clean the device and cuff with a slightly moistened cloth.
• Do not use detergents or solvents.
• Never immerse the device in water or other liquids.
• When storing the device, make sure no heavy objects are
placed on top of it. Remove the batteries. Ensure the Air
Tube does not have any sharp kinks.

11. Troubleshooting Guide

8:30 10/29
In case of errors, " _" will appear in the LCD Display, where
"_" is a number 1-6. Error messages may appear if:
• Pulse rate could not be measured (
• Systolic or diastolic pressure could not be measured (
• The cuff is fastened too tightly or loosely (
15
.
)
)
)