Playcore Swing-N-Slide PB 9242 Instrucciones De Ensamblaje página 30

LA 6347 Bighorn_- 11/29/11 9:02 AM Page 30
Assembly Plan
Fig. 22
(2)
2-1/2'' screws
per joint
Rock Wall Assembly.
1. Assemble Rock Wall as shown in (Fig. 22). Make sure to space the 5/4'' x 6'' boards as evenly as possible.
2. Mount Rocks to wall in a pattern that will allow your child to access the deck easily. Mount rocks per
instructions below.
3. Attach the Rock Wall to the unit as shown in (Fig. 22a).
Climbing Rock Installation
1. Mark locations of Climbing Rocks on the
Climbing Wall in a pattern that will easily
allow your child to climb to the deck. Make
sure the bolt hole locations are clear of wall
supports before drilling.
2. Drill holes through the wall at the desired
locations using a 3/8" drill bit. Install Climbing
Rocks as shown in (Fig. 22b).
3. Make sure the Climbing Wall and Climbing
Rock connections are secure before allowing
any children to play on the Climbing Wall.
(6) [PF 4017] 5/4'' x 6'' x 40-1/4''
2-1/2'' GAP
BETWEEN ALL
BOARDS
2-1/2'' screw
Fig. 22a
NO MORE
THAN A
3'' GAP
(3)
2-1/2'' screws
per joint
UNDER DECK VIEW
Fig. 22b
(2) 1-1/2'' Hex Head Bolts
(1) Loc Washer per bolt
(1) Flat Washer per bolt
WARNING:
Verify Rock Hardware BEFORE Drilling Holes
30
(2) T-nuts
3/8" Holes
Hold (rock)