Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Dash Disassembly
ISO DIN radio provision with pocket
1. Remove the metal "DIN" sleeve and
trim ring from the aftermarket radio.
2. Mount the ISO brackets to the radio with the
screws supplied with the radio. (Figure A)
3. Snap the pocket into the lower opening
of the radio housing. (Figure B)
4. Slide the radio into the upper opening
of the radio housing until the side clips
engage. (Figure B)
5. Snap the ISO trim plate into the radio
housing. (Figure C)
6. Connect the climate extension harness
to the climate control harness removed
in step 2 of disassembly, and then into
the 99-5826CH radio/climate panel.
7. Locate the factory wiring harness in
the dash. Metra recommends using the
proper mating adapters from Metra and
AXXESS to integrate your new radio. Re-
connect the negative battery terminal
and test the radio for proper operation.
8. Reassemble the dash in reverse order
of disassembly using the 99-5826CH
radio/climate panel instead of the
factory radio trim panel.
(Figure A)
(Figure B)
(Figure C)
DIN radio provision with pocket
1. Remove the metal "DIN" sleeve from
the aftermarket radio.
2. Slide the sleeve into the upper opening of
the radio housing and secure by bending
the metal locking tabs down. (Figure A)
3. Snap the pocket into the lower opening
of the radio housing. (Figure B)
4. Slide the radio back into the sleeve
until it clicks in.
5. Connect the climate extension harness
to the climate control harness removed
in step 2 of disassembly, and then into
the 99-5826CH radio/climate panel.
6. Locate the factory wiring harness in
the dash. Metra recommends using
the proper mating adapters from Metra
and AXXESS to integrate your new
radio. Re-connect the negative battery
terminal and test the radio for proper
operation.
7. Reassemble the dash in reverse order
of disassembly using the 99-5826CH
radio/climate panel instead of the
factory radio trim panel.
3
Kit Assembly
(Figure A)
(Figure B)
Publicidad
Capítulos
Tabla de contenido
