Machine Handling - CombiSteel SL Instrucciones De Funcionamiento

EN
Do not lean on or sit on the
open door.
If the door is accidentally opened, the
dishwasher has a special safety response
that immediately stops it, limiting the
escape of hot fluids. The sound pressure
level of the dishwashers is below 70 dB(A).
3. DESCRIPTION, CHARACTERISTICS
AND INTENDED USE
The dishwashers are designed to wash
various types of crockery, dishes and glasses
of gastronomy businesses such as bars,
restaurants, canteens, etc.
Any other use without express permission,
or failure to follow the instructions given in
this manual, will void the warranty.
Items contaminated by petrol
or paints, pieces of steel or iron,
corrosive or alkaline chemicals
and solvents, must not be
washed in the dishwasher.
Aluminium items must be
washed using chemical products
suitable for that material.
2
6
5
7
4
32
1 – CE data plate
2 – Control panel
3 – Adjustment foot
4 – Detergent and rinse aid
dosing access panel
5 – Basket support
6 – Lower wash arm
7 – Tank filters
3.1 Dishwasher versions
Control panel with
electromechanical buttons
1
3
Electronic control panel
with LCD display
4. INSTALLATION
During installation, connection and start up,
strictly observe the following instructions.
The dishwasher must be
installed by specialised
personnel, in compliance with
the safety regulations in force in
the place of use, and following
the instructions given below.
Always wear personal protective
equipment to carry out this type
of operation.
Failure to follow these
instructions will void the
manufacturer's warranty on
functional performance and/or
damage to the machine.
If your dishwasher is found to
be damaged when unpacked,
contact the dealer before
using it.
The machine must be transported to the
installation site on the pallet supplied,
using a pallet truck or forklift.
The location must be a professional and not
a domestic environment, having industrial
type wall or floor drains with drain tanks
allowing an outflow of at least 3 l/sec.
Make sure the floor at the installation site is
flat and can take the weight of the machine
full of water with a fully loaded rack (+40%
of the net weight).
4.1 Storage
Before installation the machine can be
stored in a sheltered and dry place, with
temperatures ranging between 5°C and
40°C. At the first installation or after long
idle periods it is advisable to manually
rotate the wash and rinse pump impeller
(rinse pump for PRS versions) to free it from
possibly adhering.

4.2 Machine handling

The machine must be handled
by qualified personnel who have
adequate experience and training
regarding:
- the applicable safety
regulations;
- the ability to identify dangerous
situations and adopt the
appropriate behaviour
The packed machine must be unloaded and
transported with a forklift truck, making
sure to slot the forks in the pallet frontally.
Once on the ground, before being taken to
the installation site, remove the packaging,
lift the machine with the forks between the
pallet and base, always in a diagonal and
rear position, lift then remove the pallet
and position the machine on the ground.
Using a pallet truck (suitable for the weight
to be lifted - see net weight in the data
table), slot the forks under the base of
the machine, placing cardboard between
the pallet truck and the machine to avoid
damaging it.
Do not lift the machine too high from the
ground during transport and make sure the
route is flat and free of any obstructions.
Before moving the machine, check the
passageway size of doors and the space for
steering operations.
33
EN