CombiSteel SL Instrucciones De Funcionamiento página 20

EN
Version with electromechanical controls
(alternative)
Adjustable detergent
dispenser 0 ÷ 0,82 gr/sec
Adjustable rinse aid
dispenser 0 ÷ 0,12 gr/sec
Version with electronic controls,
LCD display
Fixed detergent dispenser 0,82 gr/sec
time setting from control panel
Fixed rinse aid dispenser 0,12 gr/sec
time setting from control panel
To correctly dose the amounts of detergent
and rinse aid follow the manufacturers'
directions given on the packaging, which
vary according to the type of dirt, water
hardness and tank capacity.
Insert the suction tubes of the dispensers,
equipped with ballast, in the detergent and
rinse aid containers (not supplied).
38
When changing the type of
detergent or rinse aid, drain
the tank and boiler completely,
connect the dispenser suction
pipes to a hot water tank and
run 3 washing cycles. This
operation is necessary in order
to prevent the products from
crystallising with possible
damage to the dispenser.
6.3 Electromechanical version
Close the door and start the machine by
pressing the ON/OFF button (1), the Power
ON indicator (2) lights up and water loading
starts. Once the pre-set level is reached, the
tank and boiler have been filled, and the
boiler heating element starts heating the
water inside. Once the set temperature
is reached, the boiler heating element is
deactivated and the one in the tank starts
heating the water.
When the set temperature is reached, also
the tank heating element is deactivated
and the machine ready-to-wash indicator
(3) lights up. The temperatures can be
viewed on the indicators, if present.
Carry out at least 3 washing cycles to
allow the detergent and rinse aid to start
circulating.
For machines without detergent dispensers,
manually place directly into the tank the
amount of detergent recommended by the
manufacturer.
Exaggerating with quantities
creates excessive foam that
can cause the wash pump to
malfunction.
Open the door, insert the rack with the
dishes to be washed, select the wash cycle in
minutes with the "cycle time selector" (6), if
present. Press the "start cycle" button (4),
the "wash cycle ON indicator" (5) lights up
and the machine starts washing.
The cycle ends when the "wash cycle ON
indicator" (5) goes off, and it is possible to
proceed with other cycles.
At the end of service always drain the water
in the tank: open the door, remove surface
filters if present, and overflow pipe and
attend emptying.
Remove the plastic pump filter
only once the tank has been
emptied.
If the machine is fitted with a drain pump
(option), press the "start drain pump
button" for 3 seconds (7) to drain the
machine, after removing the overflow pipe.
(if present)
6.4 Electronic version with LCD
display (first switch-on)
When the machine is switched on for the
first time, the display shows a series of data
that the installer must enter.
Once the data has been set, it will no longer
be requested when switching on, unless the
initial state is restored from the menu.
39
EN