R Epair; Arranty; S Torage; Isposal Nvironmental Com Patibility - SUHNER GEM 6 Documentación Técnica

With normal loads, the sleeve drive must be oiled with a
few drops of oil, applied via the slot in the sliding surface.
Cleaning and lubricant changing must both be done on
the master screw every 100 h.
Under extreme loads, the master screw may get greased
by the grease nipple.
An excessive collection of grease around the master
screw can lead to malfunctions (cleaning is required).
4.2 r
ePAir
If despite strict observance of the manufacturing and test-
ing method the machine should happen to fail, it must be
repaired by an authorized SUHNER agency.
In all orders to the manufacturer please indicate the com-
ponent serial number.
4.3 w

ArrAnty

In the event of the tool being improperly handled, used
for purposes for which it is not intended and/or of the ser-
vice and maintenance instructions not being observed by
non-authorized persons, no warranty shall be in effect for
damages/consequential damages. Complaints can only
be honored if the machine is returned in the undisassem-
bled condition.
4.4 s
tOrAge
Temperature range: 20°C to +50°C.
Max. relative air humidity: 90% at +30°C, 65% at +50°C.
4.5 d / e
isPOsAl nVirOnmentAl cOmPAtiBility
This machine consists of materials which can be dis-
posed of in a recycling process. Before disposal, render
the machine unusable. Do not throw the machine into the
garbage collection.
According to national regulations this machine
must be recycled in an environmentally-friendly
manner.
35