Ford F-Serie Manual De Instrucciones página 38

• Make cuts as outlined to remove damaged areas, then make a 4" long insert/backer for repair up to
the floor pan flange. (Refer to Figure 3).
• Option 1 - Insert/backer may be installed using eight (8) blind rivets (W702512-S900C) and adhesive.
(Refer to Figure 3).
INSERT BACKER
VIEW A
Option 2 - Insert/backer may be welded into section after MIG butt welding of cross member sections. Dress butt
•
weld and fully weld insert/backer into position. (Refer to Figure 4).
BLACK WAVY LINES
REPRESENT WELD
• (Refer to Figure 5) for location for adhesive material.
NOTE: The location of SPR and adhesive shown below are based on the original production drawings
and should only be used as a guideline. (Refer to Figure 5).
BLACK WAVY LINES REPRESENT THE ADHESIVE IS BETWEEN THE CROSS MEMBER AND
THE FLOOR PAN AND THE SIDE SILLS
SEE VIEW A
CPR © 2016 FORD MOTOR COMPANY
DEARBORN, MICHIGAN 48121
4-16
FIGURE 3
FIGURE 4
FIGURE 5
SKFL34-1610696-AB
F-SERIES SUPER CAB AND CREW CAB - #3 REAR
FLOOR CROSSMEMBER INSTALLATION -
SERVICE KIT INSTRUCTIONS
SHEET 3 OF 3