Ford F-Serie Manual De Instrucciones página 72

F-SERIES BODY INSTALLATION FOR CREW CAB REAR ROOF PANEL REINFORCEMENT -
Part Number
FL34-1650291-A*
SKFL34-1650291-AB
Part Number
W707638-S900C
Motorcraft TA-1, 3M 8115 or
Fusor 108B
SERVICE GUIDELINES:
• Aluminum repairs should be performed in an area protected from steel working areas, and tools used in
aluminum repair should be quarantined from steel repair tools.
NOTE: If SPRs are called out in the materials table and procedure as a possible repair option, the
replacement SPRs must be installed adjacent to the original SPR Locations.
• Blind rivets may be installed in original SPR holes, after they are reamed out to 6.5mm. Be sure to grind all
surfaces of the flange smooth prior to blind rivet installation in original SPR locations.
• Flow Drill Screws (FDS) are to be replaced by blind rivets only. The original location of the FDS is used, but
reamed out to 6.5mm.
• Rivets may be removed by drilling, grinding, or SPR gun set up as a rivet removal tool.
• Using heat (not exceeding 425°F) to loosen a rivet bonded panel should only be done when all panels in the
joint will be replaced or separated and new adhesive applied.
• Flange preparation for adhesive is to grind to clean metal with 80-120 grit, clean, and then apply the adhesive,
spreading it out with an acid brush, covering any exposed aluminum.
• Clecos are an excellent way to hold the panels into position when fitting and drilling rivet holes.
SERVICE KIT INSTRUCTIONS
Rear Roof Panel Reinforcement Panel - Crew Cab
Instruction Sheet
NOT INCLUDED IN KIT (PROCURE LOCALLY)
Blind Rivet
Metal Panel Bonding Adhesive
CPR © 2016 FORD MOTOR COMPANY
DEARBORN, MICHIGAN 48121
4-16
KIT
Description
Description
SKFL34-1650291-AB
F-SERIES BODY INSTALLATION FOR
CREW CAB REAR ROOF PANEL REINFORCEMENT -
SERVICE KIT INSTRUCTIONS
Quantity
1
1
Quantity
4
1
SHEET 1 OF 2