1-04-2006
11:36
Pagina 38
RAMMING Appia V
RAMMING
S
mming units, proceed as
can be carried out with
NOTE: This procedure can be used for all
n.
amming function for each
ary to hold down the con-
for 5 seconds
7.3
will begin to flash.
gramming mode for the
ables the setting mode for
rating parameters.
RAMMING COF-
OSES
mount of water for each of
ceed as follows:
with the right amount of
or single filter holder can
g to the key to be pro-
der in the group.
elivery keys:
7.4
begin to dispense and
quantity has been delive-
inued key
.
.
All manuals and user guides at all-guides.com
• Delivery will cease and the selected dose
key will switch off (the other keys will conti-
nue to flash).
• Press the continued key
the programming function or to continue
programming other dose keys
groups on the machine, although it
must be performed on one group at a
time; the other groups will continue to
operate as normal.
PROGRAMMING HOT
WATER
• Use the relevant procedure to enter the pro-
gramming function.
• Press the hot water selection key
• Hot
water
delivery
• Decide the required amount of hot water
and then press the
key
• Press the continued key
the programming function or to continue
programming other selection keys.
PROGRAMMING THE
CUP WARMER (optio-
nal)
• Enter the programming mode for the first
group following the usual procedure.
• Press the cup warmer select key
• The delivery buttons for the first and second
group will respectively show the automatic
switch on and off times, while the continuous
to exit
keys
will flash.
As shown in the table, each of the delivery
keys has an associated value; the switch on
time for the cup warmer is given by sum-
ming the values for the lit keys of the first
group. The same calculation method is
used for the switch off time of the cup war-
mer, using the keys of the second group.
Key
.
will
begin.
again
to exit
.
for the first and second group
Group 1
Group 2
(on time)
(off time)
2 min.
5 min.
10 min.
4 min.
20 min.
8 min.
40 min.
16 min.