Programming Standard Doses; Copying Dose Settings; Programming Operating Parameters - Appian Nuova Simonelli Instrucciones De Manejo

1-04-2006 11:36 Pagina 39
7.7
RAMMING STAN-
DOSES
ter pre-set values for the
water (steam).
ssary to press the key
The adjustments listed here below must
d it down for at least 10
ONLY be performed by a Specialist
Technical Engineer
shing keys switch off.
If you hold down the
second group, after first entering the program-
N 1CL 2CL
ming mode for the first group, this will access
c 50 cc 85 cc
the machine parameters setting mode; this is
signalled by the continuous key
WATER
the second group, which will switch on.
9 sec.
.
of 0 seconds for steam
ans this function will work
NG DOSE SET-
y the dose settings for
r 3.
1. Enabling the pump during levelling.
the continuous key
p 2 or 3 for at least 8
Use the espresso key
enabling during levelling:
if the key
s stop flashing.
together with the level; if it is switched off, the
pump is not enabled with the level function.
All manuals and user guides at all-guides.com
PROGRAMMING OPE-
RATING PARAMETERS
CAUTION
key of the
1. Enabling the pump if the level is enabled.
2. Enabling the software block to enter the
dose programming function.
3. Adjusting keypad brightness.
4. Enabling the hot water pump (on machi-
nes fitted with economiser).
5. Disenabling the cup warmer
6. Restoring default settings.
is lit, the pump is enabled
2. Enabling the software block to enter the
dose programming function.
Use the long coffee key
software block to programme doses (key lit) or
to de-activate the block (key off).
3. Adjusting keypad brightness..
The 2 long coffees key
group is used to choose the key brightness set-
ting from 5 pre-set levels.
Use the
for
change the level, lowering it to minimum or
returning it to maximum.
4. Enabling the hot water pump (machines
fitted with economiser only).
Use the hot water key
to switch on while hot water is being delivered.
If the key is lit, the pump will switch on
while hot water is being delivered; if it is swit-
ched off, the pump will not switch on.
5. Disenabling the cup warmer..
Use the
to set pump
cup warmer operation. If the key is lit, the cup
warmer will operate normally as set during pro-
gramming; if the key is switched off, the cup
warmer is disenabled.
to enable a
of the second
key, which will flash, to
to set the pump
key to enable or disenable
39