Appian Nuova Simonelli Instrucciones De Manejo página 45

1-04-2006 11:36 Pagina 40
7.8
ot enabled, the
on during the Flash-test,
will have no effect when
To enter the automatic cleaning mode, switch
the machine off and then on again, holding
key of the
down the hot water
the modified values and
tting machine operating
At the end of the Flash-test, the
t settings
Press the
ore default settings, i.e.
cycle for the relevant group.
h pump, maximum bright-
enabled.
Once the washing cycle has been completed, it
meters, it is sufficient to
is possible to perform a rinse cycle for the same
e using the key
group by pressing the
pressos and 2
keys of the first group at
To perform the rinse cycle at a later time, switch
off the machine and the card will store any clea-
ning cycles that need to be completed in its
memory. In fact, the next time that the machi-
ne is switched on, the machine card will auto-
matically open the group cleaning status
without it being necessary to press the
and
Hold down the
seconds to exit the cleaning mode in the event
that there are no cycles to be completed. For
incomplete cycles, the
groups that require rinsing will continue to flash.
All manuals and user guides at all-guides.com
AUTOMATIC GROUP
CLEANING CYCLE
and cup warmer
keys during the initial Flash-test.
keys and the single long coffee key
of all groups will begin to flash.
key to start the washing
key again.
keys.
and keys for 2
keys of the
Hold down the
seconds more to force exit from the cleaning
mode, resetting all information about rinse
cycles still to be completed.
When a cleaning cycle is complete,
the key for the group will switch off.
and
If there are no more rinse cycles to be perfor-
med, the card will exit the cleaning mode.
and keys for 2