Checking The Contour Of A Sewing Pattern; Sewing - JUKI LK-1942ZA5050 Manual De Instrucciones

2. Checking the contour of a sewing pattern

WARNING :
• Make sure without fail of the contour of the sewing pattern after selection of the sewing pattern.
If the sewing pattern extends outside the work clamp feet, the needle will interfere with the work
clamp feet during sewing, causing dangerous troubles including needle breakage.
• Do not depress the start switch while confirming the pattern shape. If you depress it, the sewing
machine will start sewing.

3. Sewing

B A
Feeding frame
1) Set a workpiece on the feeding frame section.
2) Depress the pedal A, the feeding frame will come down. If depressing the pedal again, the feeding frame
will go up.
3) Depress the pedal B, and the sewing machine will start sewing.
4) When the sewing machine finishes sewing of the pattern, the needle tip returns to its initial position and
the feeding frame goes up.
To carry out sewing, two conditions have to be satisfied, i.e., "heat cutter has no fault" and
"safety cover is closed". If the sewing machine is not able to perform sewing, check the
aforementioned two conditions.
Refer to the Instruction Manual for the sewing machine for additional information.
1) Depress the feeding frame switch to its first step
to lower the feeding frame.
2) Every press on the
frame will move by one stitch. Keeping the key
held pressed, the feeding frame will move contin-
uously.
3) If the key is pressed, the needle point will
return to the starting position, and the feeding
frame will go up.
If the feed is fed by one stitch, detach
your foot from the pedal.
B
A
Start
– 9 –
or key, the feeding
End of sewing