Transport And Installation - Abicor Binzel MF3-Laser Front/Rear Instructivo De Servicio

MF3-Laser Front/Rear
WARNING
Risk of crushing
Hands can be pulled in and crushed by moving wheels.
• Do not reach into moving wheels.
NOTICE
• Please note the following instructions:
 3 Product description on page EN-5
• Only qualified personnel are permitted to perform work on the device or system.

6.1 Transport and installation

DANGER
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed, or worn parts.
• Power to the device should be disconnected when mounting all parts.
CAUTION
Risk of injury
Physical injury due to falling devices and add-on components.
• Select a suitable location when unpacking the device.
• Avoid abrupt lifting and setting down.
• Do not lift the components above persons or other devices.
• Transport the components in an upright position.
• Attach the drive to a device or a robot, if necessary with an insulating plate.
• Use suitable assistance to help mount the device.
• Position the robot so it can be easily mounted.
• Make sure it is standing firmly on the ground or other surface.
• Wear your personal protective equipment: safety shoes with steel toe caps, protective gloves, safety helmet, ear
protectors.
• Send bystanders out of the danger zone.
• Note the weight of the individual components.
 3.1 Technical data on page EN-6
The MF3 Laser Front/Rear front drive is part of the MFS-V3 system and comes without a connector set and quick coupling.
NOTICE
• Mount the connectors in line with the selected system.
• Ensure clear access to the control elements and connections.
• Protect the components against rain and direct sunlight.
• Use the device only in dry, clean and well-ventilated rooms.
BAL.0511.0 • 2019-06-13
6 Commissioning
EN - 11