Maintenance Intervals - Abicor Binzel MF3-Laser Front/Rear Instructivo De Servicio

10 Troubleshooting

9.2 Maintenance intervals

NOTICE
• The specified maintenance intervals are standard values and refer to single-shift operation.
• Visually inspect the wire feed rolls and the pressure rolls once a week.
When using arc welding equipment, always observe the provisions of EN 60974-4 Inspection and testing, as well as any
national laws and regulations.
Check the following:
Daily
• Visual inspection for abrasion or damage to the
wire feed rollers.
Tab. 15
Maintenance intervals
10 Troubleshooting
DANGER
Risk of injury and device damage when handled by unauthorized persons
Improper repair work and modifications to the product may lead to serious injuries and damage to the device. The
product warranty will be rendered invalid if work is carried out on the product by unauthorized persons.
• Only qualified personnel are permitted to perform work on the device or system.
Please observe the attached document "Warranty". Please consult your retailer or the manufacturer in case of any doubts
and/or problems.
NOTICE
• Consult the documentation for the welding components.
Fault
Wire is not fed
Wire is not
sufficiently fed
(slippage)
Tab. 16 Troubleshooting
EN - 22
Weekly
Basic cleaning is recommended, and necessary in the event of
extreme working conditions.
Blow compressed air through the wire conduit and check for wear.
Cause
• Motor defective
• Dirt and debris on the wire feed rollers
• Contact pressure too low
• Friction on the cable assembly too high
MF3-Laser Front/Rear
Solution
• Check by specialized personnel
• Replace motor gearbox
• Clean the wire feed rollers
• Correctly set the contact pressure
• Blow out wire conduit
• Check how the wire conduit is laid and optimize
as needed (bend large radii as little as possible)
BAL.0511.0 • 2019-06-13