Festo SPC200 Guía De Referencia Rápida página 14

Documentation and
software versions software versions
for the SPC200
System manual
version 0503c
System manual
version 0304b
System manual
version 9904a
WinPISA 4.4x (Hand
buch−Version 0504c)
WinPISA 4.3x (manual
version 0304b)
WinPISA 4.1x
(manual version
0104NH and 0206a)
1)
In each case basic unit and subcontroller module
2)
Does not support drives type DNCI..
3)
Only support for drives DGP.. and DGO.., does not support new NC
commands and extended NC syntax
4)
Does not support field bus module DeviceNet
5)
Note the different effect and syntax of the NC commands
6)
Note the instructions on the movement test, see section 1.2
7)
If you use the new NC commands and extended NC syntax, it is not
possible to upload programs or to use the debug mode
Caution
WinPISA as from Version 4.3 offers an extended scope of
functions with the SPC200 with operating system as
from 4.6. The new NC commands and extended NC
syntax are not supported by the control panel.
14
Operating system versions
as from V4.8x
(12−2004)
Compatible
Compatible
with limita
5)
tions
Mit Einschränkungen kompati
5) 6)
bel
Compatible
Compatible
with limita
5) 7)
tions
Compatible with limitations
5) 6) 7)
1)
2)
V4.6x
(10−2003)
5)
Compatible
Compatible
5)
Kompatibel
Compatible
Festo SPC200−... 0504c English
3) 4)
V3.8x
(08−2001)
Compatible
with limita
5) 5)
tions tions
Compatible
Compatible
with limita
5) 6) 5) 6)
tions tions
Compatible