Husqvarna 28508915044 Manual Del Usuario página 10

10
- Remove screw .
- Remove nut .
- Pull the entire chainguard upward.
- Remove screws .
- Remove the fairing from the chainguard.
- Remove the wiring harness of the turn signal from the brackets and
take off the chainguard.
- Remove the wiring harness of the turn signal from the brackets.
- Remove the cable tie.
- Disconnect the plug-in connector
- Slip out the wiring harness of the turn signal and remove the
license plate holder support.
- Remove screws on both sides.
- Remove screw .
- Remove the turn signal wiring harness from the brackets and
remove the license plate holder support.
- Remove screws and pull off the turn signal bracket.
- Disconnect the plug-in connector of left turn signal
signal .
- Disconnect license plate lighting plug-in connector
- Remove the turn signal wiring harness with the license plate holder.
NOTE
Right turn signal = green adhesive tape on the cable
Left turn signal = red adhesive tape on the cable
.
and right turn
.