Husqvarna 28508915044 Manual Del Usuario página 12

12
- Position license plate holder support
- Thread all the cables through the opening.
- Position groove pieces (included).
Groove engages in the carrier.
Route all the cables free of tension and ensure that the
cables cannot be kinked or pinched!
- Mount screws with collar bushings
to 5 Nm (Loctite 243).
- Plug in the socket connector for the right turn signal and for the left
turn signal into the turn signal wiring harness
NOTE
Right turn signal = plug into black and brown
Left turn signal = plug into purple and brown
- Mount rubber grommet (included).
- Thread turn signal wiring harness
as shown.
- Thread the cable of the license plate lighting through the rubber
grommet as shown.
- Mount cable ties (scope of supply).
- Route the cable without tension and secure with cable ties.
Route all the cables free of tension and ensure that the
cables cannot be kinked or pinched!
Assembly
- Remove screws .
- Remove passenger seat handle.
- Remove screws of the right side fairing.
NOTE
If necessary, remove the tool set.
- Remove screw on the right.
- Remove screw on the right.
- Carefully pull the right side fairing out slightly.
(included).
(all included) and tighten
(included).
through the rubber grommet