BEBE CONFORT MiloFix Manual Del Usuario página 40

EN
particular the metal parts, from becoming hot
and burning the child.
• A fter putting your child in the seat, ensure that
the harness straps are properly tight. Also ensure
that the strap is not twisted.
• A fter putting the child in the car seat, ensure
that the harness is sufficiently taut by pulling the
belt. Ensure also that the belt does not become
twisted.
WARNING:
never combine two ISOFIX anchorage and car seat
belt systems to install your child car seat.
ATTENTION:
in ISOFIX use the fitting clips for lower anchorage
to the vehicle is not sufficient. It is essential to fix
the "Top Tether" to the upper anchorage point
recommended by the car manufacturer.
"Fitting the MiloFix seat with additional tethers
using the vehicle's ISOFIX additional anchorage
points.
The ISOFIX anchors have been developed to
obtain a safe and easy fixation of the child safety
systems inside the car. Not all cars are equipped
with these anchors although they are standard on
more recent models. Consult the attached list of
cars for which the car seat can be installed
correctly (you can also consult additional updates
of this list on the website www.bebeconfort.com)"
• I n rear-facing position (GR0+), this product must
42
( )
not be installed to places equipped with a
frontal air bag. You might be able to deactivate
it (see your car manual). In this case, if you can
deactivate the air bag, you can use the car seat
on the front seat.
• I n forward facing position (GR1), the seat must
be placed on the car rear seat or exceptionally
on the front seat in accordance with the
legislation in force in the country of use (In
France: in accordance with the conditions
stipulated in decree n° 91-1321 du 27-12-1991). If
you use the MiloFix on the front seat, it should
be possible to deactivate the airbag of the seat
in question or move the passenger seat back to
a maximum (Please consult your car manual).
• W hen installing the seat in the rear-facing
position, the belt of the top tether can turn one
quarter turn according to the position of the
anchorage point. This does not impair the
proper operation of the product.
• W hen installing the car seat, it is necessary to
remove the headrest in order to put the top
tether through correctly.
• W arning: when installing the car seat, spaces
between the base of the car seat and the vehicle
seat are possible depending on the position of
the anchorage points within the vehicle.
• I t is essential that the car seat be replaced after
an accident.
• T he user must always check that any luggage
and other objects likely to cause injury to the
occupant of the car seat in the case of impact
are properly secured.
• T he rigid parts and the plastic sections of a child