Yakima Q Stretch Kit Manual Del Usuario página 8

a
The objective:
1. Cam Cover closes with firm and equal resistance on both sides of the vehicle.
2. Gold Slider positions are equal on both sides of the vehicle.
Rear towers must be centered on vehicle!
b
The technique:
at a time, alternating from driver's side tower to passenger's side tower. Close the Cam Cover after
each adjustment. Only one Cam Cover can be open at a time.
START
HERE
alternate from
driver's side to
passenger's side.
1033431D-8/30
Your installation will be complete once you achieve balanced tower tension.
BALANCED TOWER TENSION REQUIREMENTS
R8A9N1D
Slowly tighten your towers by turning the adjustment posts clockwise one full turn
While holding the
clip in place with
your thumb, tighten
adjustment post one
turn, then...
Perform this technique on both the driver side and passenger side in
an alternating fashion until you achieve balanced tower tension.
Install System
Gold sliders must be aligned!
lower cam cover
with opposite
thumb until cam
cover is under
tension, then...
use both thumbs
to snap the cam
cover shut.
bring both thumbs
up to cam cover...