Publicidad
Idiomas disponibles
Idiomas disponibles
Unscrew the battery cover using a coin.
Remove the old battery.
Insert the new battery (Lithium 3-V CR2) paying attention to follow polarity indicated under the collar (See.
Diagram 2).
Retighten the battery cover using a coin. A beep sound is emitted indicating the correct installation of the battery. If you do
not hear any beep sound when retightening the battery cover, remove the battery immediately from its housing. Check the
polarity before trying again.
NOTE: when changing the battery, there can remain some power in your collar. In that case, the collar does not emit any beep
sound when you retighten the battery cover after inserting the battery. To make sure it operates properly and that the battery is
correctly installed, turn your collar on with the magnetic key.
Attention: After each change of battery, reconnect your collar in Bluetooth with the application CANICALM Smart, so
that time and mode are well updated. Without this operation your collar will be in beeping mode alone and the hours of
barking cannot be communicated to the application.
Likewise if you use the collar without application, please re-select your mode (see § Changing the operating mode). By
default, the collar returns to beep only mode.
The battery charge level can also be seen through the CANICALM Smart app. To do this, refer to the battery symbol on your
smartphone when connected via Bluetooth.
Changing the contact points
●
Two different series of contact points are supplied. The length of the contact points must be sufficient to have proper contact with
the dog's skin, enabling the device to operate correctly (proper barking detection and correct transmission of the stimulations).
If you have a long-haired dog and the short contact points fitted to the collar in the factory are inadequate, remove and replace
them with the long ones supplied with the kit.
Carefully tighten them manually (do not use a key).
Checking the device operates properly
●
You can at any time check the correct functioning of your collar by proceeding as follows:
Before performing this operation, make sure your collar is off (indicator light off).
Place each wire of the test lamp under each of the electrodes (by unscrewing and then tightening them so as to pinch the
wires of the test lamp under the electrodes).
Turn on the collar with the magnetic key.
Slide a ribbed object (eg insulated-handled tooth knife) onto the bark detection electrode (see Fig. 1). Change the detection
sensitivity if necessary (via the CANICALM Smart application on your smartphone).
The collar should beep and the test lamp should light up (the test lamp does not turn on in mode 1 as it is the beep mode
only). Also make sure you are in an active time slot (see Parameter Settings via the application of the CANICALM Smart.)
Before disconnecting the test lamp, make sure the collar is off.
Collar adjustment
●
Collar adjustment is very important. In fact, this setting determines the proper barking detection and the correct transmission of the
stimulations.
The strap should be adjusted so that the contact points come right into contact with the dog's skin:
If the strap is too loose, the collar will not operate properly. Moreover, the collar is likely to move and repeated friction can
irritate the skin of your dog.
If the strap is too tight, the dog will have breathing difficulties.
The strap is properly adjusted when you can insert two fingers between the strap and your dog's neck.
If necessary, replace the short contact points with the long ones supplied with the kit (See § Changing the contact points).
Do not leave the collar more than 8 hours per day on your dog. Check your dog's neck regularly. If irritations appear,
remove the collar until all signs of skin irritations have disappeared.
Troubleshooting
●
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
Guide d'utilisation version complète – User's guide full version CANICALM Smart – indice B
Battery charge level
27/100
Publicidad
