Mantenance; Troubleshooting; Transportation; Storage - FITFIU FITNESS PV-200 Manual Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

MANTENANCE

After each use, stop the machine and make sure it is turned off.
Store the vibration platform in a dry, dust-free and well-ventilated place. Make sure the machine is not exposed
to sunlight.
Verify that storage and transport environments meet requirements and check for security risks.
Clean the control unit only with a dry or slightly damp cloth.
Clean the rubber surface with a wet cloth and soap. Do not use corrosive detergents such as gasoline or solvents,
do not allow liquids to enter the mechanism.

TROUBLESHOOTING

Symptom
1
Platform does not turn on
2
The switch is not on.
3
Fuse blown
The machine emits sounds
4
during operation
The machine does not
5
respond to the remote
control
6
Suddenly stopped working
Machine does not
7
respond to remote control
commands
NOTE: lf this still can't help you solve the problem, please contact us and our engineers will help
you deal with it. Thanks!.

TRANSPORTATION

The product has a wheel at the bottom right of the device and handles. Pull up on the left side and move the machine
to the desired location. Avoid severe vibration, shock or rain during transport.

STORAGE

The vibrating platform should be stored off and unplugged in a well ventilated room without corrosive gas. The
ambient temperature should be -10°C to +50°C relative humidity should be less than 93% (non-condensing) and the
atmospheric pressure should be 50-106 kPa.
Possible cause
Plug not connected
Power switch is not on
The machine's engine makes a normal
noise during operation
-The batteries are exhausted.
-The control is too far from the
machine
The default operating time has
elapsed
You may have pressed multiple
buttons and sent multiple commands
at once.
43
Solution
Connect the plug
Press the power switch and turn on
the machine.
Replace with a new fuse
That's normal.
-Replace batteries
-The infrared signal works at 2.5m..
Resuming time using the remote
control
Turn it off and on again
PV-200
EN

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido