Cycle Start And Special Functions; Program Start; Changing The Setpoint Value During A Fi Ring - Pixsys ATR 900 Manual Instalador

Press
3
4
8

Cycle start and special functions

8.1 Program start

Press START/STOP and follow the points below:
Press
1
2

8.2 Changing the setpoint value during a fi ring.

Controller is operating a cycle: follow the points below.
Press
1
Display
Press to skip to the 1
of the next program.Press
to end programming and press it
again to start the fi ring cycle
Display
Value on display changes
Program starts and buzzer
sounds briefl y. From now on,
display shows the actual tem-
perature of the kiln.
Led START is On.
Display
Pressing the key it is possible
to visualize setpoint of current
step. If this function is active
 
, press once again the key
to modify it. After a few secon-
ds display will shows process
and setpoint value is stored.
To fi nish the fi ring cycle, enter

'END' is displayed). If auxiliary
output is enabled, select
close the relay or
st
segment
Main display shows
Press the key to scroll through
the available programs and
fi nally the function "simple
controller
chosen program is displayed.
Enter new setpoint value.
Do
(keep pressing

to open it.
Do
   

, until the
To stop or pause the fi -
ring cycle, press
Do
until

to
.
.
13 GB