8.3 Jump to the next segment during the cycle
Controller is operating a cycle: follow the points below.
Press
1
Press
the key
for 3 s.
8.4 Function HOLD
Controller is operating a cycle: follow the points below.
Press
1
Press
the key
for 3 s.
8.5 Visualize Power consumption
Press
1
8.6 Funtion WAITING
During rising segments , the controller usually jumps to the next segment of cycle
only when the kiln reaches the programmed setpoint value. In case that the kiln
is not able to reach setpoint within the given time (due for example to excessive
load), the controller would hold the running segment until the process reaches
the setpoint.
GB
14
Display
The controller jumps to the
next segment of the running
cycle
Display
The
controller
temperature which is currently
visualized on display until the
key CYCLE is pressed by the
operator again. The display
visualizes alternating the tem-
perature value and the writing
.
Display
Press the key to visualize the
power consumption during last
cycle. Enter the plant power on
to rate power consum-
ption.
holds
the
The function can be interrup-
ted by pressing the key
again for a few seconds.
Do
Do
Do