Recovery; Function Simple Controller - Pixsys ATR 900 Manual Instalador

Ocultar thumbs Ver también para ATR 900:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

The function WAITING allows to set a fi xed waiting time on parameter 16
in this case the controller waits only for the fi xed time before jumping to the next
segment. When this function is working and the controller jumps to the next
segment as result, the display will visualize
by pressing the key STEP or START. P-16 set to zero means that the function is
desabled. The function does anyway not work during holding and cooling ramps
as well as during rising steps if time is set to zero.

8.7 Recovery

The function allows the recovery of an interrupted cycle and the fi ring prosecution in
case of black-out. It may be activated by setting parameter P-17 to 1. If the function
has been previously activated, the cycle will restart from the point of interruption.
The controller stores both the running cycle and the interrupted segment.

8.8 Function SIMPLE CONTROLLER

ATR901 may also be used as a "simple controller" according to a fi xed setpoint.
Press STOP and follow the sections below.
Press
1
3
4
5
Display
Flashing digit changes.
Display
the
setting and to increase or
decrease it. After a few seconds

is displayed again.
The actual temperature of the
kiln is shown. Led STARTS to
fl ash. Control output is active.
Display
shows temperature
setting .
Increase or decrease the value.

Keep
display shows
temperature
Enter chosen setpoint
To modify the temperature
setting, see following section
no. 5
To exit the function "simple
controller", press
. The writing may be stopped
Do
pressing

 
,
until
.
.
15
GB

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Atr 901

Tabla de contenido