SATA J Serie Manual Del Uso página 19

Operation:
1.Start/stop （see Figure B） :
Press and hold switch （1） to start the machine tool, then release it to stop the machine tool.
2.Speed regulation with switch:
Force applied to the switch can change the speed. The change range is from 0 to maximum speed. When the force applied is low and the
speed is low, the starting speed will be low, making the tool stable and easy to control. After a stable and reliable start, fully press down
the switch for a higher speed.
3.Speed position selection （see Figure C） :
During use, select the gear and control the speed with the switch. Upon delivery, the machine tool is set at the highest gear. The gear
indicator （ 6） is provided by three red indicators. If 3 red indicators are on, this indicates a high gear; if 2 red indicators are on, this
indicates a medium gear; and if 1 red indicator is on, this indicates a low gear. If the gear selection must be changed, press the icon to
change through the gears one by one.
Warning:
Do not press the switch for a long time when operating at low speed as this will cause the internal part of the machine tool to
become overheated. Change the speed gear of the machine tool after each stop.
4.Switch locking （see Figure D） :
The switch has a locking protection function will is beneficial for helping to reduce the possibility of misstarting the machine tool after a
period of disuse. Adjust the reversing yoke （2） to the central position when the machine is not used so as to lock the machine tool.
5. Change of rotation direction （see Figure D） :
Forward: Push the side of reversing yoke （2） marked with "
Reverse: Push the side of reversing yoke marked with "
Warning:
The rotating speed can only be changed after the machine is completely still.
6. Installation and removal of socket （ see Figure E） :
Caution:
When installing or removing the sleeve, be sure to confirm that the drill has been turned off and that the battery pack has
been removed.
1）Socket without O-ring and pin:
a）Install the socket: Press it onto the square drive bit （ 1） of the tool until it is fully in position.
b）Remove the socket: For removal, it is only necessary to pull it out.
c）Tap it gently if necessary.
51075
" to the end （right side） for releasing or unscrewing the screw the screw.
中文
" to the end （left side） for drilling and driving the screw.
EN DE RU KO PT JA ES
19