Dismantling; Disposal; Accessories; Additional Information - Derungs Dmed Triango 80 C Instrucciones De Montaje Y Funcionamiento

Triango 80 F
CAUTION
►
The luminaire head must be installed before the
spring force is adjusted.
►
Move the spring balanced arm to the highest position.
►
Remove the lateral plastic covers and press the round
plastic flap along the spring balanced arm upward.
►
Adjust the screw with a 4 mm Allen wrench.
►
Turn the screw clockwise (+) to increase the spring force
(if the spring balanced arm lowers).
►
Turn the screws counterclockwise (-) to reduce the
spring force (if the spring balanced arm rises).
10

DISMANTLING

DANGER
Death hazard from electric shock.
Before dismantling the luminaire, disconnect all pins from
the power supply.
WARNING
Injury hazard
The spring balanced arm is under a high spring force. If
the terminal device is not in the uppermost spring balanced
arm position, the spring balanced arm will move rapidly
upward and cause severe injury. Only dismantle the
terminal device when the spring balanced arm is in the
uppermost position

10.1 Disposal

Do not discard the luminaire with household waste.
Follow local regulations and bring the luminaire to
a disposal site or give it to a dealer with appropriate
service.
Cut the cable directly at the casing.
The products listed above are over 95% recyclable.
For a high percentage of the used materials to be
either physically reused or used for energy after the
end of this product's life cycle, the luminaires have
been designed with recycling in mind. They do not
contain materials that are hazardous or require
monitoring.

11. ACCESSORIES

Hand grip (order No. D10.295.000)
12

ADDITIONAL INFORMATION

The luminaire itself is maintenance free.
Additional documents may be requested from the manufacturer
for this product.
Using this luminaire does not pose a risk to other equipment.
To save energy, the luminaire should be switched on only
when it is actually needed.
Any serious incident that has occurred with the product must
be reported to the manufacturer or their representative and
the responsible authorities of the country in which the user is
located.
ENG
37