中文
AE5602T
EN
DE
RU
KO
PT
JA
ES
2.3 Use of Wedge for rear wheels
In the Kingpin measurement, to prevent the vehicle moving,which affects the measured data, block the rear wheel
by rubber wedge, and then take out the pins on turn plate and remove the rubber pad. (For reference only)
2.4 Selection of Clamps
2.4.1Four Wheel Aligner Special Clamps Introduction
The clamps with four claws is specially designed for four wheel alignment, which can align common type as well as
the type with low chassis. Good looking and easy to use. as following picture:
56