Brill 270 RT Tipp Manual Del Usuario página 23

nearest authorised specialist
dealer.
Caution! Repairs that
A
require specialist
knowledge must only be carried
out by an authorised specialist.
Caution! For safety rea-
A
sons, only use original
Fault
Cutting lines disappear into
line reel.
Cutting line cannot be
lengthened.
10. Instructions for correct use, safety instructions
Check each time you use
A
the equipment
Inspect the equipment each time
before you use it. Do not use the
equipment if safety devices
(switch handle, safety covers)
and / or if the cutting device is
damaged or worn. Never dis-
able safety devices.
Check the work area before
starting work. Remove any for-
eign bodies present (e. g. stones,
branches or bones). Check for
foreign bodies whilst working.
Always wear sturdy shoes and
long trousers when working.
Never work barefoot or when
wearing only light sandals.
Check the cutting tools regularly
for damage and have them
repaired correctly if necessary.
spare parts supplied by the
manufacturer or parts that have
been authorised by the manu-
facturer.
We expressly point out that in
accordance with product liability
laws, we are not liable for any
damage caused by our units if
this damage is due to improper
Possible Cause
Line reel not installed properly.
Cutting line is used up.
Cutting line is trapped.
Reel installed incorrectly.
Only have cutting tools
replaced by Brill Service or your
authorised specialist dealer.
Use /
A
Responsibility
Make sure that there are no
other people (especially children)
or animals within or near the
working area.
Powered equipment can cause
serious injuries! You are respon-
sible for safety in the area where
you are working.
Always use the equipment solely
for the purpose described in the
operating instructions.
Only use this unit in daylight or
when the area where you are
working is lit by ample artificial
lighting.
repair or if parts exchanged
are not our original parts or
parts approved by us, and if
the repairs were not carried
out at service centre authorised
by the manufacturer or by an
authorised specialist. The same
applies to spare parts and
accessories.
Remedy
Remove line reel and
install again
(see Point 8 Maintenance ...).
Install new line
(see Point 8 Maintenance ...).
Remove line reel, unwind line
and roll up again
(see Point 8 Maintenance ...).
Remove / install line reel
(see Point 8 Maintenance ...).
Ensure that you are standing
safely and on firm ground, even
on a slope.
Be careful if you are going back-
wards, risk of stumbling!
Only push the equipment at
walking pace.
Turn the motor off if the equip-
ment has to be tilted when trans-
porting it over surfaces other
than grass and if you are trans-
porting the equipment back-
wards and forwards to the work
area. Never use the machine
with damaged protective devices
or without protective devices.
When starting or operating the
starter switch take care as stipu-
lated by the manufacturer's
instructions. Ensure that your feet
are far enough away from the
cutting tool.
GB
23