Connection And Operation - Migatronic PI 500 ROBO Guía De Usuario

Connection and operation

Warning
Read warning notice and
instruction manual carefully
prior to initial operation and
save the information for
later use.
Permissible installation
Mains connection
Connect the machine to the correct mains supply.
Please read the type plate (U
machine.
0
l
1
Connection of shielding gas
Connect the gas hose, which branches off from the
back panel of the welding machine (3), to a gas supply
with pressure regulator (2-6 bar). (Note: Some types of
pressure regulators require an output pressure of more
than 2 bar to function optimally).
Important!
In order to avoid destruction
of plugs and cables, good
electric contact is required when
connecting earth cables and
welding hoses to the machine.
) on the rear side of the
1
2
2
12
11
6
5
4
10
9
7
8
1. Mains connection
2. Power switch
3. Gas hose
4. Connection of shielding gas
5. Connection of earth clamp or electrode holder
6. Connection 7-pole plug (TIG)
7. Connection of cooling hoses
8. Connection of cooling hoses
9. Cooling liquid level control
10. Refill of cooling liquid
11. Connection of remote control
12. CAN connection
Connection of welding hose
11
1
Power
F
F
F
Gas 2-6 bar
3