SATA 53121 Manual Del Uso página 11

e）Don't stretch your hands too long. Always pay attention to the foothold and the balance of the body.
f ） Appropriate dress. Don't wear loose clothes or wear ornaments. Let the clothes,gloves, and hair away from the moving parts.
Loose clothes, ornaments or long hair may be involved in moving parts.
g） If a device is provided for connection with chip removal and dust collecting equipment, make sure that they are well connected
and properly used. It can reduce the dangerous caused by dust with these devices.
4） Usage and attention of electric tools:
a）Do not abuse electric tools and use proper electric tools according to their usage.Choosing the right electric tools will make you
work effective and safer.
b）If the switch can't turn on or turn off the power of the tool, you can't use the electric tool. An electric tool that can't be
controlled by a switch, it is dangerous and must be repaired.
c）The plug must be disconnected the power supply or the battery box with the tools before doing any adjustment, replace
accessories or store electric tools.
This protective measure will reduce the accidental start of tools.
d）Store electric tools out of children's range.Do not let people who don't know how to and unfamiliar with the instructions operate
electric tools. Electric tools in untrained users are dangerous.
e）Maintenance of electric tools. Check whether the sports parts are in place or stucked.Check the damaged parts and affect the
operation of electric tools. If damaged, should be used after the repair of electric tools.
Take good care of it. Many accidents are caused by poor maintenance of electric tools.
f ）Keep cutting tools sharp and clean. Well maintained and sharp.
cutting edge tools are not easy to be stucked and easy to control.
g）According to the instructions, consider the operation condition to use electric tools accessories and cuttings. Otherwise, it is
dangerous.
h）In general workplace, class n tools should be used;When class I tool is used, the rated residual action should also be adopted in
the electric circuit. Residual current operated protector with current less than 30mA.
Protection measures from transformer and so on.
i ）Under wet workplaces or metal frames which increase electrical conductivity.
n or class in tools should be used in the workplace.
j ） In operation areas such as boilers, metal containers, pipes, etc.
Use class HI tools or class II residual current operated protector is not larger than 30mA that in the electric circuit is equipped
with a rated residual current.
k） The safety isolation transformer of class ID tool and the residue of class n tool.
Power control box of current action protector of II and in tools, and power coupler must be placed outside the workplace.
When operating in a narrow workplace, keep someone supervising outside.
l ） In the humid heat, rain and snow and other working environment, we should use corresponding prevention tool.
m） The green / yellow line of class I power supply wire can be only used as a protective grounding wire（PE）in any case.
n） The power line of the tool must not be arbitrarily lengthened or replaced. The power cord is not enough for operation distance,
we should use coupler.
o）The plug and socket of the tool should be properly connected.
The protective grounding electrode in the socket can only be connected protective grounding wire（PE）in any case. Plugs and
sockets directly connect the protective grounding pole to the working line by wire is strictly prohibited.
p） Dangerous movement of tools and protection devices for components, such as protection, cover, etc. shall not be dismantled
arbitrarily.
5） Maintenance:
Send your electric tools to professional maintenance personnel with the same spare parts to repair, which will ensure the safety of
the electric tools.
53121/05153
中文
EN DE RU KO PT JA ES
11