Publicidad
Idiomas disponibles
Idiomas disponibles
This tool applies action mode switch button, and you can choose a mode suitable for your work needs through this knob. When only need
rotating, make the arrow on the knob point to the symbol on the tool. When need rotating and attacking, make the arrow on the knob
point to the symbol
on the tool.
Note:
Please make sure that the knob is completely set on the required symbols. If the knob is in the halfway position between the
two modes, the tool may be damaged
The knob can be rotated after the tool is completely stopped.
Torque Limiter:
When a certain torque level is reached, the torque limiter begins to work. The motor will be out of the output shaft. At this point the bit
will stop turning.
Note:
Once the torque limiter moves, turn off the tool power switch immediately. This helps prevent the abrasion of the tools.
The drilling bit, such as a hole saw, is easily clamped or locked in the hole and is not suitable for simultaneous use with the tool.
Because these tools will cause the torque limiter to start too frequently
Installation:
Note:
Before operating on the tool, make sure that turn off the power switch and remove the plug
1 ） Install or uninstall a drilling bit.
2 ） Before installing the drilling bit, clean the bit and scribble the bit oil.
53121/05153
1 ）Side handle
2）Unscrewing
3）Screw tight
中文
EN
DE
RU
Action mode change
KO
PT
JA
ES
13
Publicidad
